Advertisement
Safety instructions / Handling
All of the used components within this device fulfill the actual European standards for safety and handling.
Please place the loudspeakers on a rigid horizontal ground. Install the speakers that they are stably
positioned. Do not expose the loudspeakers to strong sunlight. Don't place the speakers nearer than 40cm in
front of a window.
The room climate should be dry.
When transporting the loudspeakers, wrap them in our packing material. Cover the membranes with the
stable cardboard which was packed with the loudspeakers. Always move the loudspeakers with two people.
When you place them on the floor, please put them carefully on the back edge of the base plate and set them
upright afterwards. Never put them on the corners of the base plate as the corners are not strong enough. Do
not move the loudspeakers on the floor. Otherwise the floor could be damaged.
Please prevent small children to touch the loudspeakers, especially the membranes.
The amplifier must be free to get sufficient air for cooling. A minimum distance from 3cm to a wall is enough.
The angled plug gives the minimum distance.
Prevent any liquid getting inside the amplifier module. When cleaning the box always unplug the mains cable
first.
The device can only be opened by a specialized person. If the loudspeaker seems to be damaged unplug it
from the mains and call your local specialist.
The fuses can be changed from outside. Always unplug the loudspeaker from the mains when you change
the fuses. Use the same tipe of fuse when exchanging the fuses. A second fuse is packed in the small fuse
holder.
When a thunderstorm is announced, the loudspeakers should be unplugged from the mains to prevent a
shock through lightning. A special mains power strip can reduce the risk of damage.
The membranes of the speakers are very sensitive and can easily be damaged. They should be touched very
carefully for cleaning (see care instructions).
Technical data
Full Active 2-Way Loudspeakersystem
Tweeter:
Woofer-Midrange:
Active Electronics with Adaptive Output Impedance System
Sensitivity for 90dB SPL @1m:
Input Impedance:
Input Overload:
Signal to Noise Ratio:
Power RMS:
Continuous Max. SPL@1m:
Frequency Response (-6dB):
Crossover Frequency:
Roll Off below 400Hz:
Signal Input:
Voltage:
Power Consumption:
Box Material:
Baffle Material:
Net Weight:
Dimensions: HxWxD
Technical adaptions are subject to change without notice
© by KLANGWERK GmbH, Zürich, Switzerland
25mmØ / Titan-Membrane, Waveguide, Acoustic Lens
3x 145mmØ / HDA-Membrane (High-Definition-Aerogel)
245mV (adjustable)
balanced, 5kOhms
20Vpp
-96dBA
40+30W
103dB
39Hz-22'000Hz
1500Hz
0dB - 3dB/Oktave
XLR F/3P
115/230V (50-60Hz)
7-70VA
MDF Nextel anthracite
CREANIT®, white, light grey
19kg
1045x210x168mm
7
Advertisement
