Samsung PPM63M7FS Service Manual page 35

Troubleshooting
4-2-2 How to Access Service Mode
1. general Remote
To enter: POWER OFF
(Interval between key strokes: less than 3 sec)
To exit: POWER OFF
2. Factory Remote
To enter: POWER ON
POWER OFF
To exit:
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), factory (Dynamic Ce Off)
4. Adjustment Procedures
- Channel ▲▼ key
- Volume ◀▶ key
- MeNu key : Save the changes to the eePrOM and return to the higher-level mode.
- using the Numeric (0~9) keys, you can select a channel.
- using the SOurCe key, you can switch aV modes.
5. Initial SerVICe MODe DISPlaY State
Panel on Time (hour) 00000
1. Calibration
2. option Table(Service)
3. white Balance
4. SVP-uX
5. Option Block
6. SgTV5810/NTP3000
T-CP2MWWMf-XXXX
T-SfrMWWS-XXXX
SaffrON_Tr-XXXX
Mon/Day/Year
hout/Min/Sec
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
4-14
Info Menu
POWER ON
INFO Factory Key (Interval between key strokes: less than 3 sec)
POWER ON
: Select an item.
: adjust the value up or down.
Mute POWER ON
SAFFRoN Component
7. YC Delay
8. Adjust
9. I2C Check
10. W /B MOVIe
11. Checksum
12. r eset
Boot Merge : Ok
DBg MODe
Samsung Electronics