Yamaha CLAVINOVA CLP-120 Service Manual page 16

CLP-120
20-7. Remove the screw marked [6a] to remove the PL
circuit board. (Fig.19)
20-8. Remove the six (6) screws marked [6b] to remove
the keyboard holder assembly. (Fig.19)
20-9. Remove the four (4) screws marked [7] to remove
the angle K. (Fig.19)
Angle K
21. Back Top Panel Assembly
(Time required: about 3 min)
21-1. Remove the top board assembly. (See Procedure 1)
21-2. Remove the two (2) screws marked [40], the five
(5) screws marked [41c] and the three (3) screws
marked [52] for each side. The back top panel
assembly can then be removed. (Fig.18)
22. Side Board Assembly L, R
(Time required: about 4 min for each)
* For safety, make sure to perform by two persons.
22-1. Remove the main unit. (See Procedure 18)
22-2. Remove the four (4) screws marked [S4]. The side
board assembly L, R can then be removed. (Fig.20)
23. Pedal Box Assembly (Time required: about 4 min)
* For safety, make sure to perform by two persons.
23-1. Remove the pedal assembly. (See Procedure 17)
23-2. Remove the four (4) screws marked [S4]. The
pedal box assembly can then be removed. (Fig.20)
16
Holder Assembly, Keyboard
[7]
[6b]
[6a]: Bind Head Tapping Screw-1 3.5X20 MFZN2BL (EP0305800)
[6b]: Bind Head Tapping Screw-1 3.5X20 MFZN2BL (EP0305800)
[7]: Bind Head Tapping Screw-1 4.0X40 MFZN2Y (V5344700)
Pedal Box Assembly
[S4]: Truss Head Screw 6.5X25 MFZN2BL (VQ448400)
Front Rail Assembly
[6b]
(Fig.19)
Side Board Assembly (R)
Side Board Assembly (L)
[S4]
(Fig.20)
[7] Angle K
PL
[6a]