Table of Contents
Advertisement
How to program
SETTING UP MIDI ACTIVE
In this menu, the CTL switches can be made "MIDI active".This means that by every preset change, the
control number and value of the toggle switches is also sent out. Every switch can be programmed individually
to work as normal or MIDI active.
Press the MENU-button and scroll to TOGGEL SW using the >-button. Press the MENU-button again and it
will say CONTROL NR. in the display. Scroll to submenu "MIDI ACTIVE" using the >, < buttons and press the
MENU-button. It will say SW 1-------NORMAL in the display. Choose switch number using the UP/DOWN
buttons, and NORMAL/MIDI active mode using the >< buttons.
End the session by choosing QUIT in the submenu and subsequently choosing QUIT in the main menu.
SETTING UP LOOP MODE
In this menu the CTL switches can be reprogrammed to control loops in the MAC1 real-time. Every switch
can be programmed to ON/OFF control loop 1thru8, SW A or SW B.
The LED above each switch will indicate the ON/OFF status of the loop, and is updated by the MAC1 every
time a new preset command is sent.
This feature only works with a fully mounted MIDI cable.
Press the MENU-button and scroll to TOGGEL SW using the >-button. Press the MENU-button again and it
will say CONTROL NR. in the display. Scroll to submenu "LOOP MODE" using the >, < buttons and press the
MENU-button. It will say SW 1-------NORMAL in the display. Choose switch number using the UP/DOWN
buttons, and use the >< buttons to determine which loop the chosen switch should control.
End the session by choosing QUIT in the submenu and subsequently choosing QUIT in the main menu.
Copying presets
To make programming as easy for you as possible, the BIGFOOT has a copy-preset
function, which enables you to copy data from one preset to another.This feature is
situated in the main menu.
Press the MENU-button and scroll to COPY using the >-button. Press the MENU-button
again and it will say FROM 1---------TO 1 in the display.
Use the UP/DOWN buttons to choose from which preset should be copied.
Use the >< buttons to determine to which preset should be copied.To execute command
press the BANK OP switch, and it will say "OK" in the display
Press the MENU-button to exit.To end the session choose QUIT in the submenu and
subsequently choose QUIT in the main menu
the toggle switches
(continued)
12
Advertisement
Table of Contents
