Operation; Funcionamiento - Craftsman 315.EL2200 Operator's Manual

WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
serious injury.
WARNING:
Always remove the battery pack from
the product and disconnect the AC power cord when
you are assembling parts, cleaning, or when not in
use. Removing these energy sources will prevent
accidental starting that could cause serious personal
injury.
WARNING:
The radio/charger is not waterproof. Do
not submerge in liquid. Failure to heed this warning
could result in serious personal injury.
NOTICE:
Always refer to the manual for any
device recommended for use as an attachment or
accessory. Proper use of any device, when attached
to the radio/charger, is the sole responsibility of the
operator. Improper use may damage the device or
the product.
WARNING:
This radio is capable of producing
sound levels that can be dangerous to long-term
hearing. Listening to music at high volume for any
period of time can cause noise-induced hearing loss.
The higher the volume, the less time required before
your hearing could be affected.
APPLICATIONS
You may use this product for the purposes listed below:
 Listening to AM/FM radio, MP3 players, CD players,
and other audio devices
 Charging 19.2 V battery packs and USB capable
devices
 Streaming audio from BLUETOOTH
For complete charging instructions, refer to Charging
later in the Operation section.
ATTACHING VERSATRACK BRACKETS
See Figure 1, page ii.
 Push the VersaTrack brackets into the slots on the
back of the radio, as shown.
 Slide the brackets up to lock them in place.

OPERATION

INSTALLING/REMOVING AAA BATTERIES
See Figure 2, page ii.
It is advisable to write down saved channels before
replacing the AAA batteries.
There is a 15-second time frame for replacing the AAA
batteries. If the batteries are not replaced within 15
seconds, the radio will lose all settings previously stored
in memory, and they will require reprogramming.
Always use new alkaline batteries for replacement.
 Remove the AC power cord from the cord wrap.
 Loosen the screw in the battery door. Remove door
 Install two new AAA batteries according to polarity
 Replace the battery door and tighten screw to secure.
CHARGER ONLY OPERATION
See Figure 2, page ii.
A switch has been installed in the bottom of the AAA
battery compartment. The purpose of this switch is to
disable the radio circuits so that the charging functions
of the radio/charger can be tested for compliance with
California Energy Commission requirements for Battery
Charger systems. If the switch is in the up position, the
radio/charger will operate normally; if the switch is in the
down position, the radio circuits will be disabled while the
charger circuits continue to function normally.
You should not need to operate this switch under normal
use conditions. However, if you find that the radio is
not working while the charger seems to work normally,
confirm that this switch is in the up position.
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page ii.
enabled devices
®
 Place the battery pack in the radio/charger, aligning the
 Make sure the latches on the battery pack snap into
 Depress the latches to remove the battery pack.
AC POWER CORD
See Figure 4, page ii.
The AC power cord can connect the radio/charger to a
power supply when a battery is not available or when a
battery has a low charge. The power cord has a pass-
through plug which allows you to connect the radio/
charger and another device to the same outlet.
8 - English
WARNING:
Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
and set aside.
indicators inside the battery compartment.
rib on the battery pack with the groove in the battery
port.
place and the battery pack is secured to the radio
before beginning operation.