Advertisement
FSP-8
8-Channel Digital signal processor
U s e r M a n u a l
Installing the FSP-8
Installation of this product requires technical knowledge and experience.
If you are uncertain of your ability to install it, we strongly recommend having your Focal dealer install
it for you, so that you will be able to take full advantage of your FSP-8.
The following section deals with issues related to the vehicle which must be considered before installing your
FSP-8. You'll save time by planning the system layout and wiring in advance.
During this preparatory phase, please ensure that all the settings remain accessible once the installation is
complete.
Before starting the installation, please follow these instructions carefully:
1 - After thoroughly reading the user manual, make sure you have understood all the instructions before
installing your FSP-8.
2 - Disconnect the battery's negative wire before starting installation. (fig.A)
3 - To facilitate assembly, we recommend you unwind all the wires before installing your FSP-8.
4 - Route all RCA, speaker driver, REM and remote control cables away from the power cables in order to
avoid any signal interference.
5 - Use quality connectors for the FSP-8 terminals to ensure a reliable installation and to minimise any losses
of signal or power.
6 – Before carrying out any operations, be extremely careful not to cut or drill through the fuel tank, fuel,
brake, hydraulic or vacuum lines, any electrical wiring or safety devices.
7 - Never route a wire under the vehicle. Wiring must be installed inside the vehicle to ensure better
protection. When routing the cables, make sure they do not impede your driving. Cables obstructing or
routed through areas such as the steering wheel and pedals (brake, airbag, accelerator and clutch, etc.)
may be extremely dangerous.
8 - Avoid routing wires over or through sharp edges. Any wire routed through metal must be protected with
a grommet. Route the wires away from mobile parts (seat rails...) and from sharp or pointed edges. This
will avoid getting the cables caught or damaging the cables.
9 - Always protect the battery and electric circuit from potential damage using fuses. Install a fuse holder
and adequate fuse on the 12V positive (+) power cable less than 15" (40cm) away from the battery
terminal. Ideally, the above-mentioned distance should be as short as possible (fig.G).
10 - Prepare the chassis ground by scraping off any traces of paint on the metal surface in order to ensure
proper grounding. The grounding connections should also be as short as possible and ALWAYS be
connected to metal welded to the body or the chassis of the vehicle (fig.D). The ground point which is
generally chosen is the one connecting the negative terminal of the battery to the chassis of the vehicle.
1 – Positioning your FSP-8
Where to install your FSP-8
Due to the power of the FSP-8, heat dissipation is required for correct operation. This is why the FSP-8 must
be placed in a well-ventilated area. Do not cover your FSP-8 as this may cause overheating.
NEVER install this product in the engine compartment of the vehicle. This will void the warranty.
2 – Fastening the FSP-8 in place
Install the device on a support which will avoid damaging the vehicle.
Position your FSP-8 at the desired location and make match-marks.
Place the FSP-8 on the support, then fix the device securely in place using the 4 screws supplied.
Notice_FSP-8.indd 17
17
20/01/17 12:24
Advertisement
