Firmware Upgrade - Philips EXP4318 User Manual

General information

Firmware upgrade

Occasionally, Philips releases new software ("firmware") for your unit.
1
Connect the power adapter to 4.5V DC on the unit and to the power outlet
(see "Power adapter").
2
Keep MODE pressed for 3 seconds.
➜ The type of your unit and the current version
of the firmware are displayed.
displayed.
Press 9.
3
4
Visit the Philips Audio homepage www.audio.philips.com. Check if there is a
firmware file for your unit and if the firmware version is higher than the current
version of your unit. Download the file and burn it on an 8 cm CD-ROM.
5
Insert the CD-ROM into the unit and keep MODE pressed for 3 seconds.
➜ is displayed.
Press 2;:
6
➜
After upgrading is finished,
➜
or the downloaded file does not correspond to your unit.
➜
during the download or when burning the CD-ROM. Download the file
again, burn a new CD-ROM and try again.
➜
CD-ROM.
Note: If upgrading is interrupted accidentally, repeat steps 5 and 6 until upgrading
is completed successfully.
12
is displayed and upgrading starts.This may take some minutes.
is scrolled:Your unit already has the latest firmware
is scrolled:The upgrade file has been damaged
is scrolled: No upgrade file was found on the inserted
is
is scrolled.