Firmware Upgrade; Power Supply; Batteries - Philips EXP511 User Manual

EXP511,513/00c.1 eng 1/3/02
General information

Firmware upgrade

Occasionally, Philips releases new software ("firmware") for your set.
1
Connect the mains adapter to 4.5V DC on the set and to the wall socket
(see "Mains adapter").
2
Keep MODE pressed for 3 seconds.
The type of your set and the current version of the firmware are displayed.
Upgrade? is displayed.
3 Press 9.
4
Visit the Philips Audio homepage www.audio.philips.com. Check if there is
a firmware file for your set and if the firmware version is higher than the
current version of your set. Download the file and burn it on a CD-ROM.
5
Insert the CD-ROM into the set and keep MODE pressed for 3 seconds.
Upgrade? is displayed.
Press 2;:
6
Upgrading is displayed and upgrading starts.This may take some minutes.
After upgrading is finished, Upgrade complete is scrolled.
Wrong upgrade file is scrolled:Your set already has the latest firmware
or the downloaded file does not correspond to your set.
Upgrade file defect is scrolled:The upgrade file has been damaged
during the download or when burning the CD-ROM. Download the file
again, burn a new CD-ROM and try again.
No upgrade file is scrolled: No upgrade file was found on the inserted
CD-ROM.
Note: If upgrading is interrupted accidentally, repeat step 6 until upgrading
is completed successfully.
12
15:11 Page 12

Batteries

(supplied or optionally available)
Inserting batteries
Open the battery compartment and insert
2 alkaline batteries of type AA (LR6, UM3).
Do not use old and new or different types of
batteries in combination.
Indication of empty batteries
Replace the batteries or connect the
mains adapter as soon as A blinks and
Replace batteries is scrolled.
Remove batteries if they are empty or if the
set will not be used for a long time.
Batteries contain chemical substances,
so they should be disposed of properly.
Average playing time of batteries under normal conditions:
Alkaline
batteries
ESP on 10 hours
ESP and powersaving on:
Audio disc 15 hours
MP3-CD 20 hours
Note:To switch on powersaving, press ESP repeatedly during
playback until is shown (see "ESP and powersaving").

Power supply

ECO-PLUS
NiMH batteries
5 hours
7 hours
10 hours
13