Page 2
Wa�age, advanced safety protec�ons and ‘Vape while charging’ Technology. The CoolFire MINI has a variable voltage range of 3.0 – 7.5 volts adjustable in .1 volt increments and a variable wa�age range of 6.0 – 40.0 Wa�s, adjustable in .5 wa�s increments.
Page 3
Please check and verify that your CoolFire MINI is an authen�c Innokin Technology WARRANTY INFORMATION: product. Innokin Technology provides a 90 day a�er sales service warranty to all authorized To verify this CoolFire MINI is a real Innokin Technology device please: vendors.
Page 4
Innokin is not responsible for any atomizer or ba�ery damage due to the use of CoolFire MINI and enjoy vaping with it in the most safe and effec�ve ways possible. low quality e-liquid, dry herb, or other materials for which the CoolFire MINI 1.
Page 5
5V 1A USB wall charger (CE/UL Cer�fied) “+” bu�on: CoolFire MINI /VW+ 13. The CoolFire MINI Advanced Personal Vaporizer is not designed for use with a car “-” bu�on: CoolFire MINI /VW- charger. This product does not come included with a car charger.
Page 6
” three �mes to turn on the CoolFire MINI. Once the Ba�ery Level Indicator: CoolFire MINI is on, hold down the power bu�on to ac�vate the atomizer. When the CoolFire MINI is not in use, press the power bu�on “...
Page 7
The screen will display " TOO HOT " if the PCB is overheated. unsafe condi�ons. The CoolFire ACE features automa�c real-�me PCB Chipset temperature The CoolFire MINI features automa�c real-�me atomizer Ohms detec�on. If the detec�on. resistance of the atomizer is lower than 0.2, the Ohms bar will blink and the CoolFire MINI will not power on.
Page 8
“-” bu�on: CoolFire MINI / VW- display the a�ached atomizer resistance, voltage and wa�age and remaining ba�ery charge. All CoolFire MINI se�ngs can be easily changed without the use of a menu system. The large OLED screen readily displays all important informa�on.
Page 9
To POWER OFF the CoolFire MINI : Adjust Variable Wa�age: When the CoolFire MINI is in variable wa�age mode press the "+" or "-" bu�on to Click 3x ON increase or decrease the wa�age. Hold the bu�on down to quickly increase or decrease the set wa�age.
Page 10
Atomizers or Drippers (RBA/RDA) may even be lower. The CoolFire MINI can fire In variable voltage mode the CoolFire MINI voltage can be adjusted from 3.0 to 7.5 volts between resistances of 3.1 to .2 ohm and you can clearly see the resistance of the in .1 volt increments by pressing the "+"...
Page 11
0.0W ‘Vape while charging’ Technology The CoolFire MINI is recharged with a Micro USB cable. When plugged into a power source the CoolFire MINI can also be vaped and charged at the same �me with Innokin Technology’s ‘Vape while you charge’ pass-through technology.
Page 12
Please skip the following sec�on about how to refill and replace a coil if it is IMPORTANT Charging Informa�on: express kit. Only charge Innokin devices with a high quality CE/UL Cer�fied 5V/1A wall charger. • Never charge a ba�ery that has been damaged or dropped. How to refill the Slipstream Tank: •...
Page 13
How to replacing a coil of Slipstream Tank: IMPORTANT INFORMATION ABOUT USING NICOTINE-CONTAINING E-LIQUIDS CAUTION: Make sure there is no e-liquid in the Atomizer / Tank before you pull out Before using nico�ne-containing e-liquids the user should read the following the coil .
Page 14
• Those who have an overac�ve thyroid gland or have a phaeochromocytoma (a • Irrita�on in the mouth or throat; tumour of the adrenal gland that can affect high blood pressure); • Dizziness; • Those who have diabetes, as nico�ne may affect your blood sugar levels. •...
Page 15
How to store the CoolFire MINI: Maximum output Wa�age: 40W Always power off the CoolFire MINI electronic cigare�e when it is not being used, or Maximum output Current: 14.5A Maximum output Voltage: 7.5V when it is going to be stored. Store the CoolFire MINI electronic cigare�e in room Clearomizer Resistance: 0.2Ohm (minimum)
Need help?
Do you have a question about the CoolFire MINI and is the answer not in the manual?
Questions and answers