Kenwood KVT-512DVD Service Manual page 3

CAUTIONS IN ASSEMBLING PANEL DRIVE MECHANISM (A10-5171)
2. Phase matching among gears
• Monitor tilt is driven under the control of the
rotary sensor and the phase matching among
gears and sensor is required.
The procedure for the phase matching is de-
scribed in the rest of this subsection.
1) Align the mark on the rack with the pin. (When
the monitor is folded down at 0 degree, the
rack is located at the position where the mark
and pin are aligned.
2) Insert the gear while keeping aligning the rack
pin with the notched section on the tilt gear 7.
3) Pre-assemble the tilt motor bracket assembly
(BKT Assy).
4) Align the notch on the sensor BKT with the
concave section of the sensor in the Assy.
5) While keeping the conditions stated in 3) and
4), insert the tilt motor BKT Assy transversally,
and fi x the motor.
T-Rack-A Pin
Location of
notched section
KVT-50DVDRY/512/522DVD
/522DVDY/532DVD/532DVDM
Tilt drive gear train
Location of mark
on the Rack
Tilt Gear 7
Location of
notched section
Sensor Tilt Sensor Bkt
3