Touch Panel Adjustment; Adjustment Procedure - Kenwood KVT-512DVD Service Manual

Enlarge OK
Enlarge OK
● Confi rmation after adjustment
After the adjustment, check that the screen is horizon-
tally symmetrical and that there is no blur on the screen.
The "HPOSI OK" will be shown to indicate the comple-
tion of the adjustment.
ADJUSTMENT

4. Touch panel adjustment

● Adjustment procedure
q Press the Touch Key on the Test Mode Menu screen to
enter the Touch panel adjustment screen.
w Touch the center of "+" mark below in the following or-
der.
Upper left → Upper right → Lower left → Lower right
To touch, make sure to use the designated touch stick.
e After adjustment is completed for 4 areas, if "Write OK"
is displayed, the adjustment is completed.
Press Return to exit from the Touch screen.
∗ If the center of "+" mark wasn't pressed accurately, press
Cancel to start over the adjustment.
Note
The touch panel adjustment data is finalized when the
touch stick is released from the mark.
Therefore, the Knack for Adjustment is not to release the
touch stick from the mark right after touching the center
of the "+" mark, but to confi rm that the stick is exactly
on the center of the "+" mark while keeping touching the
screen. (If the stick is not exactly on the center of the
mark, move the stick onto the center of the mark while
keeping touching the screen.)
Then, quickly and vertically release the stick from the
screen.
KVT-50DVDRY/512/522DVD
/522DVDY/532DVD/532DVDM
Cancel Cancel
Cancel Cancel
19