Advertisement
4. BAND button (↑or↓)
Press UP or DOWN to increase or decrease Bank, the third and fourth
digit of LED DISPLAY shows BAND NO.(01-30)
5. CHASE 1- CHASE 6
Select ddsired CHASE to be programmed or run CHASE.
6. PROGRAM
T urn the power on ,it is in MANUAL RUN mode, press PROGRAM
for 2 seeonds, corresponding LED blinks, SCENE and CHASE are
ready to be brogrammed, press PROGRAM once more to return to
RUN mode, corresponding LED goes out.
7. MIDI/ADD
A、Press MIDI key when running ,the third and fourth digit of LED
flash, select MIDI channel using UP or DOWN, press MIDI key to make
programe when in PROGRAM mode.
B、Press this key to make programe when in PROGRAM mode.
8. AUTO/DEL
A、In RUN mode, press Auto/Del, corresponding LED is ON ,which
indicates it is AUTO RUN mode, press once more to withdraw MUSIC
mode, corresponding. LED goes out.
B、Press this key to make S cene and chase program when in
PROGRAM mode.
9. TAP SYNC /DISPLAY
A、In AUTO RUN mode, running speed of scene is interval of last
TWO pressing of TAP SYNC/DISPLAY ,Max.10 minutes.
B、In PROGRAM mode, select display between STEP and BANK ,in
other mode: Select display between 00-225 and 0%-100%.
10. BLACKOUT
Press this key to disable all channel output, but not any other functions
.Press once withdraw Black out mode.
11. MIDI IN
Use to receive MIDI data.
12. DMX POLARITY SELECT
Select the polarity of DMX output.
13. DMX OUT
Use to output DMX 512 signal
14. DC INPUT
DC9V～12V ,300 Ma ,MIN.
PROGRAMMING FOR SCENES
Press PROGRAM for 3 second, appropriate LED blink ,which indicates it
in PROGRAM mode .
1. SECNE PTOGRAMMING
Ⅰ.Press SCANNER key to select DMX channel composed. Of 8
channels.
Ⅱ.Select different channel to conrtol several devices at the same time.
Ⅲ.A djust appropriate fades to select desired output level ,then turn off
fade.
Ⅳ.Selcet and adjust output level continuously until all devices are set.
Ⅴ.Press MIDI /ADD.
2. SCANNER COPY
Ⅰ. Select desired scene of bank.
Ⅱ.Make program of scene of scene to meet the requirement of device.
Ⅲ. Press MIDI/ADD ,add a programmed scenes.
3. SCENE EDITING
●Add a STEP in CHASE .Select desired LCD display Presses TAP
SYNC/DISPLAY ,the LCD shows the CHASE and its STEP, If it has
made program till the 15th step ,select the 9th using UP or DOWN, Press
MIDI/ADD, the CHASE is maintained and the STEP turns to 10th STEP.
Seleet desired SCENE using UP or DOWN ,Press MIDI/REC ,then the
new 10th STEP is added to SCENE, the previous 10th STEP turns to the
new 11th STEP, the previous 11th STEP turns to the new 12th STEP, and
so on.
●Delete a STEP in CHASE
Select desired STEP and then press AUTO /DEL .
For example, select the 10th STEP using UP or DOW, press ATUO/
Advertisement
