Samsung SV-DVD50 Service Manual page 89

(1) There are two STOP modes and two FF/REW modes.
1) STOP 1
This mode is performed when PB and FF/REW is not done for 5 miniute at power on.
The small load is given to S REEL DISC and T REEL DISC. And the cylinder motor is stopped.
2) STOP 2
This mode is performed when you press the stop button as performing FF/REW.
The large load is given to S REEL DISC and T REEL DISC.
3) FF/REW 1
This mode is performed when
ΠThe tape load is small during performing FF and reducing speed.
´ The tape load is large during performing REW.
The small load is given to S REEL DISK and no load is given to T REEL DISC.
4) FF/REW 2
This mode is performed when
ΠThe tape load is large during performing FF.
´ The tape load is small during performing REW and reducing speed
No load is given to S REEL DISK and the small load is given to T REEL DISK.
(Cf) According to acceleration, deceleration, and the location of tape, tension control which is caused by
converting FF/REW 1 and FF/REW 2 each other is performed during FF or REW.
(2) The condition of S Brake and T Brake at each mode.
< S BRAKE>
1) OFF BRAKE (Unloading completion, RPS, PLAY, FF/REW 2)
- S BRAKE is detached from S REEL DISC completely. So S REEL DISC is free.
2) SOFT BRAKE(during LOADING, STOP 1, FF/REW 1)
- The small load is given to S REEL DISC.
Samsung Electronics
Fig. 8-15
Fig. 8-16
VCR Deck Operating Description
8-13