Reel Base Retainer, Reel Base T Assembly And Reel Base S Assembly (Reel Lock Release Block And Reel Lock Release Spring); Cam Motor, Motor Holder - Sony DSR-50P Service Manual

3-14. REEL BASE RETAINER, REEL BASE T ASSEMBLY AND REEL BASE S ASSEMBLY
(REEL LOCK RELEASE BLOCK AND REEL LOCK RELEASE SPRING)
Disassembly: Remove them in order of 1,2,3
(Refer to Assembly, too.)
Reel lock release spring
Stop
2
washer
Reek lock release block
Reel base S assembly
This shaft hinders removing or
attaching the reel base S assembly.
Do the work while being careful not
to touch it.
3-15.

CAM MOTOR, MOTOR HOLDER

Disassembly/Assembly
Cam motor
Label
Claws A
Motor holder
(Release claw B at the rear.)
Screw
Pins D
Tightening torque of motor holder
±
0.1961 0.0196 N • m
±
(2.0 0.2 kg • cm)
Positioning holes of pin D
Reel base retainer
(Remove in reverse
order of assembly.)
1
Reel base
T assembly
3
Apply grease to
the three
and tip.
(half size of one
grain of rice for
each part)
120 °
120 °
120 °
Claws C
Screw
Claws A
Pins D
Claw E
Assembly: Attach them in order of 1,2,3
1 Move the reel selector slider in the direction of arrow A to
check that the reel selector lever is "L cassette". At this position,
attach the reel base T assembly. The gear teeth must be engaged
as shown in the figure.
Reel base T assembly
Good Not good
2 Move the reel selector slider in the direction of arrow B and
switch the reel selector lever to "S cassette". At this position,
attach the reel base S assembly. The gear teeth (circled by a)
must be engaged as shown in the figure.
Reel base S assembly
3 Attach the reel base retainer.
Fixing state
Note: Do not hold the shaft when selecting the reels.
Checks before disassembly and assembly
The cam motor is fixed on the motor holder by the four
parts
claws. Releasing the four claws enables the cam motor
to be removed without removing the motor holder from
the chassis. When attaching the cam motor, be careful of
the assembling direction (the label must face toward the
front). If the phase of the gear, etc. moves when removing
the motor holder, refer to page 5-11.
Claw C
Claws A
Claws A
[Rear side of motor holder]
The motor holder is fixed by the two
screws and claw B at the rear. To
remove it, push claw B in the
direction of the arrow from the rear
of the chassis. Note that positioning
pins D are easy to break when
attaching the motor holder. Apply
grease (half size of one grain of rice)
to the two parts shown in the
right figure.
5-15
Reel selector slider
A
Reel selector lever
The gear teeth circled
by a are engaged.
1
2
Attach in order of
(Attach to the slits.)
[Front side of motor holder]
While spreading claws A in the
direction of the arrow, pull out the
cam motor upward. To attach it, push
the cam motor into the motor holder
and route the two wires of the cam
motor into claw C.
When attaching the TG2 control arm,
claw E must be inserted into the
hole of the TG2 control arm.
Claw B
Pins D
Pins D
B
.
1, 2