Mineral pool-care cycler for pools up to 40,000 gallons (24 pages)
Summary of Contents for Pool Frog 6100
Page 1
Pool Frog ® Mineral Pool Care System Model 6100 For Pools up to 25,000 gallons Cleaner because it kills bacteria two ways Clearer because it helps keep pH in range Softer because it reduces chlorine use up to 50%* Easier...
Safety Precautions Notice Step 1: Preparing the Pool Step 2: Putting the System to Work Step 3: Setting the Control Dial Step 4: Routine Pool Care Replacing POOL FROG Mineral Reservoir ® Using FROG BAM ® Using POOL FROG Bac Pac ®...
POOL FROG Mineral Reservoir POOL FROG Cycler ® ® Holds the minerals and fits inside the POOL FROG Cycler. The water treatment center that controls the flow of ® Product #01-12-6112 water to each part of the POOL FROG System.
Notes and Safety Information General Notes These instructions contain information for the safe and proper These instructions do not provide for every possible contingency operation of this system. Observe the following principles: that might be encountered in connection with installation, opera- • Read the entire manual prior to installing or using this tion or maintenance of this equipment.
Safety Precautions CAUTION a Follow instructions for the POOL FROG ® SYSTEM, POOL FROG ® Bac Pacs, POOL FROG ® Minerals, and BAM ® Algaecide. a Avoid breathing in chemical fumes. Use protective equipment if necessary. a Wash your hands and arms thoroughly after using this product. WARNING Fire, explosion and high pressure hazards To minimize the risk of serious injury, death or property damage, follow these instructions and safety precautions at all times while using the POOL FROG ®...
Follow manufacturer’s directions carefully. 7.2 – 7.8 Total Alkalinity: 80 – 120 ppm Do not add shock in or near the skimmer or into the POOL FROG ® Calcium Hardness: 200 – 400 Cycler as it could damage equipment, risk potential explosion or discolor your pool surface.
When chlorine reading is down FROG Cycler, with POOL FROG ® ® to 1.0 ppm, which may take a Mineral Reservoir inserted, for few days, insert POOL FROG ® 10 minutes on Setting 5. Bac Pac. (See page 12 for directions.)
Step 3: Setting the Control Dial This system is designed to work effectively with a variety of pool equipment as long as the following basic procedures are followed. Set control dial by matching up the parameters of your pool on the chart below. THIS IS A STARTING POINT ONLY and may need to be adjusted to fit your individual pool needs.
Maintain 0.5 to 1.0 ppm free chlorine level at all times. Note: These lower chlorine levels are only acceptable when using FROG minerals. ® Remember to replace POOL FROG ® ® B R A N D Mineral Reservoir and all other FROG ®...
50%*. Simply use with at least 0.5 ppm of an EPA registered when the cap is open. source of chlorine such as the POOL FROG Bac Pac (EPA Reg. No. 53735-2) or a chlorine delivery device. Using the POOL FROG Mineral System improves swimming pool pleasure by reducing the problems associated with chlorine including faded bathing suits, premature damage to pool equipment or surfaces and smelly odors.
Setting 0. Insert upside down into center of POOL FROG Mineral ® Reservoir pushing down firmly on FROG BAM ® bottle allowing key in POOL FROG ® Cycler to puncture seal. Remove POOL FROG Cycler ® cap. Lift FROG BAM up and allow any ®...
Using the POOL USE ONLY the factory recommended replacement POOL FROG Bac Pac. (See label.) ® DO NOT USE any other pac or bulk chemical tablets in the POOL FROG Cycler. Use of any ® FROG Bac Pac ® other product could result in over chlorination, bleached liners, unsafe pool conditions, fire or explosion.
If loose or missing, it can to 1.0 ppm. is necessary. provide another avenue for water to reach the chlorine. 2. Reinsert the POOL FROG 4. Contact your dealer to have ® Bac Pac, lower the dial one your back pressure tested. If 6.
Parts List Model 6100/6500 SILICONE LUB RICANT Included with POOL FROG Cycler 6100 or 6500 Replacement parts for POOL FROG Cycler 6100 or 6500 ® ® REF. # DESCRIPTION QTY. INCLUDED REF. # PART NO. DESCRIPTION 1 & 2 Cap w/O-Ring 1 &...
Place o-ring in bottom half groove. of groove. Center of locking pin Place your thumbs on each In the back of the POOL FROG ® side of the cap over the o- Cycler depress center of locking ring in the groove.
Make sure POOL FROG Bac Pac is away ® from open flame. If empty, rinse and recycle. Remove the POOL FROG ® Mineral Reservoir and discard in Remove cap. trash. You will hear spent media inside, however it is no longer effective.
HOSE ADAPTER back pressure. For best results use our pressure gauge, order part number 01-22-4000. When using a POOL FROG ® Bac Pac, isolating the POOL FROG Cycler by installing a ®...
Base Flex-Hose Installation TOOLS NEEDED Screwdriver • Never install POOL FROG ® PUMP before the heater. • Any additional sanitizing Pipe Wrench FILTER equipment that is installed with FROG must be installed after ® FROG (never before) on the ®...
FROG Bac Pac. ® direction. 1½” Male Adapter Screw adapters into each end of POOL FROG following directions ® (slip x MPT) for a male adapter or a female adapter. Hand tighten. Finish tightening by turning 1 to 2 revolutions with wrench.
C. OPTION 2 - A 3-Way Valve Installation • Any additional sanitizing equipment that is 3-way manual valve or 3-way motor valve plus controls IN-FLOOR installed with POOL FROG must be installed POOL FROG ® ®...
POOL FROG Cycler Two-Year Limited Warranty ® Register your product online today to extend your POOL FROG warranty to 10 years. ® www.frogproducts.com/product-registration-2/ King Technology, Inc. will warrant this unit with a complete replace- B. Control dial settings in excess of the recommended set-...
Need help?
Do you have a question about the 6100 and is the answer not in the manual?
Questions and answers