Specifications; Standard Accessories; Battery Removal/Installation - Hitachi DS 14 DVB Handling Instructions Manual

SPECIFICATIONS

POWER TOOL
Model
No-load speed (Low/High)
Wood
(Thickness 18 mm)
Drilling
Metal
Capacity
(Thickness 1.6 mm)
Machine screw
Driving
Wood screw
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No. 2 × 55L) ..... 1
2 Charger (UC14SD) .......................... 1
DS14DVB
3 Plastic case ...................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EB1414)
Optional accessories are subject to change without
notice.
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
8 mm (diameter) × 50 mm (length) (Requires a pilot hole)
UC14SD
14.4 V
1.6 kg
DS14DVB
0 – 350/0 – 1200 min
27 mm
Steel: 13 mm, Aluminum: 13 mm
6 mm
EB1414 (1.4 Ah): Ni-Cd 14.4 V
2.1 kg
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Insert the battery into the charger.
Insert the battery firmly while observing its direction,
until it contacts the bottom of the charger. (See
Figs. 1 and 3)
CAUTION
The UC14SD model is the exclusively designed
charger. This cannot charge batteries except the
specified batteries. It is possible to insert the
batteries other than the specified into the charger
and some of them may light up the pilot lamps.
However, you are requested to exercise utmost
caution not to charge batteries other than
specified ones because these can not only be
charged but also such actions can result in the
malfuntion of charger.
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 20°C. The pilot lamp goes
off to indicate that the battery is fully charged.
The battery charging time becomes longer when a
temperature is low or the voltage of the power
source is too low.
When the pilot lamp does not go off even if more
than two hours have elapsed after starting of the
charging, stop the charging and contact your
HITACHI AUTHORIZED SERVICE CENTER.
CAUTION
If the battery is heated due to direct sunlight,
etc., just after operation, the charger pilot lamp
may not light up. At that time, cool the battery
first, then start charging.
3. Disconnect the charger power cord from the
receptacle.
4. Hold the charger tight and pull out the battery.
–1 (/min)
9