Actuator Channels (Status Display); Transmit Channels (Input Channels) - HomeMatic HM-OU-LED16 Installation And Operating Manual

Every connection on the status indicator must
be made as a CCU connection.
The Homematic status indicator cannot be con-
nected directly to another Homematic device,
not even if it is being used as a remote control
or button.

8.1 Actuator channels (status display)

Actuator channels 1 - 16 are always assigned to the
actuators or sensors whose status is to be displayed
using one CCU connection per channel.
The „trigger on change" of each actuator or sensor is
entered in the „if query" and the display required on
the status indicator is entered in the „then function".
If an assigned actuator signals successful receipt of
a status change command, the relevant status is dis-
played on the LED status display. Depending on the
assignment, statuses of off - red - green and orange
(mixture of red and green) are possible.

8.2 Transmit channels (input channels)

The Homematic status indicator can be used as a but-
ton/remote control for assigned actuators. Even if the
status indicator is being used as a button, every one of
its connections must be made as a CCU connection to
the corresponding actuator.
35