Table of Contents
Advertisement
3.
First make sure the frame stands firmly, and then pull the module gently along the slot till out
of frame.
4.
Install the front panel.
Setting Jumper
Item
JP02 (used to choose control signal
when communicating)
Note: you must choose only one
option
JP03 (used to choose one signal of
PVW/MON OUT in the back
connector)
JP17 (used to choose reference
signal )
JP10
ON/OFF
LED Indicator
Item（color）
POWER（green）
Auto（green）
Bypass (green)
OUT 1 (green)
OUT 2 (green)
SDI (green)
SDT (green)
1ER (orange)
2ER (orange)
SAC6840N 2X1 Switcher
Tab. 2-3 Description of SAC6840N Jumpers
Description
RXD_INT: remote control from 6800 series frame
RXD_ONET: control signal from ONET remote control
panel
RXD_BOOT: reserved
Used to choose which one will be output, Reclocked SDI
video output or analog composite output
FRM_REF: reference signal comes from common signal
provided by 6800 series frame
B_REF: reference signal is provided by Ref located at back
connector
Please set at ON if JP17 is at B_REF,
While set at OFF if JP17 is at FRM_REF.
Table 2-4 LED Indicator Function
Description
On: Power is supplied.
On: The device works on AUTO mode.
On: The device works on BYPASS mode.
On: output the first source
On: output the second source
On: SD-SDI signal
Off: ASI signal
On: 625
Off: 525
On: there is error in the first source
On: there is error in the second source
- 6 -
Advertisement
Table of Contents
