OSEE AURORA1600 User Manual page 15

equipment rack. Adequate ventilation is required when installed to
prevent possible damage to the AURORA1600 components.
Connect required cables for signal input and output.
3.
Connect power source using the included power cord.
4.
Connect the power cord to the rear panel.
5.
Fasten the power protect accessory.
6.
As a final step, power AURORA1600 on.
7.
Restore the default IP setting
AURORA1600 provides an Ethernet port for connecting with a computer
to access the network control page or run the device control tool to modify
the network settings. The default IP address of AURORA1600 is
192.168.1.70.
Restore the default IP setting by short-circuit two pairs of the
corresponding pins of RS422 interface at the rear panel.
The instructions are as below:
 Operations:
Firstly, power down the AURORA1600 device, insert a network cable
(called as Restore cable) with a RJ45 plug into the RS422 interface.
Short-circuit the two pairs of corresponding pins of RS422 interface:
Pin3(Rx-) and Pin5(Tx-), Pin4(Rx+) and Pin6(Tx+) by twisting the
corresponding wires of the network cable.
Secondly, power on the AURORA1600 and keep it running for at least 60
seconds, thus, the IP address of AURORA1600 will be restored to the
default one.
At last, power off the AURORA1600 again, and pull out the network cable
from the RS422 interface, then power on the AURORA1600, it will run
normally.
Refer to "4.2.2-7 Operations of Rear Panel-RS422" for the details about
RS422 interface of AURORA1600.
Unpack and Installation
9