Table of Contents
Advertisement
10.5 Electrical adjustment (LCD)
TOP PREVIOUS NEXT
[How to enter into the LCD panel adjustment mode]
Play back the specified video signal (10 steps, color bas signal).
Press and hold down "Back skip" and "Pause" of the main unit at the same time while pressing
"Menu" on the remote control unit.
[The DVD player is now in the FT02 mode]
Press the "Forward skip button twice to enter into the FT04 mode (LCD panel adjustment mode).
Press the "Playback" button to play back the signal which has been played back before stopping and
then, press the "Pause (still) button.
[How to exit to normal mode]
(Exit the F4 mode)
1. Turn off the primary power supply (Remove the DC power supply).
Turn on the power supply. Press the "Stop" to stop the system.
Press "Cancel" on the remote control unit (The Cancel key is enabled only when the system is
stopped.)
•Whenever the LCD panel is replaced, make the following checks and adjustments.
•Press the "Enter" key and fix the settings.
•When the EEPROM" (IC8401) of the LCD drive P.C.B. is replaced, call up the LCD drive P.C.B.
adjustment mode (FT04) and execute the AUDIO on the remove control unit and then check the
condition of the screen. Make adjustments as necessary.
10.5.1 Adjusting VCO oscillation frequency
10.5.2 Adjusting DC offset of impressed voltage
Advertisement
Table of Contents
