Table of Contents
Advertisement
IX. Care and Maintenance (After Dive)
1) After each dive, soak the sealed light in fresh water for about 20
minutes to remove any residual salt, sand and dirt. Never allow
the saltwater to dry on the light.
2) Push the power button several times to clean any saltwater or
sand trapped under the button.
3) Let the water drain out of the small holes located at the bottom of
Flex Arm. (If using Flex Arms - see page 18 for optional
accessories).
4) Dry off the light with a towel. Make sure you and the light are dry
before opening the waterproof battery cap.
5) Remove battery before storing the light.
6) Allow light to thoroughly dry before storage.
7) Never use any detergents, cleaners, solvents or chemicals to
clean the light.
8) Insert a fresh Moisture Muncher Capsule (SL911) inside the
battery compartment during storage to help keep the inside dry
and free of corrosion or mildew during storage.
12
Advertisement
Table of Contents
