Table of Contents
Advertisement
VIII. Maintaining a Waterproof Seal (Before Dive)
1) The light uses two O-rings to maintain a waterproof seal.
2) Every time you open the battery cap make sure the O-rings
and sealing surfaces are clean, undamaged and lubricated.
3) Dampen a clean cotton cloth and wipe it around the O-ring
and O-ring contact surfaces to remove any hair, sand or debris.
4) Carefully inspect the o-ring for cuts, tears or other damage.
Replace o-rings if damaged.
5) Lube O-rings regularly. Apply a small amount of silicone lube
on your finger tip and wipe it around the O-rings. Wipe off
excess lubricant. The o-ring surface should have shiny, wet
appearance.
Important:
Replace O-rings every year if damaged or not. Visit your local
SeaLife dealer or www.sealife-cameras.com for information on
ordering spare o-rings.
11
O-rings
O-rings contact surface
Advertisement
Table of Contents
