Additional headlights
(fog lights, high beam)
1. Remove cover of rubber buffer.
2 Remove Phillips screws from rubber buf-
fer and the transparent side cover with a
screwdriver.
100
3. Remove Phillips screws holding the lamp
(arrowed) and pull out the lens as a unit.
4. Disconnect wire. Push down holding
clamp for bulb.
5. Remove defective bulb and replace. Be
sure guide pins on bulb base fit into soc-
ket of reflector.
6. Reinstall lamp, tighten screws. Check
functioning and adjustment of light.
7. Install rubber buffer and side cover and
tighten retaining screws.