[User Mng.] Screen; Setup] Screen - Panasonic AK-UC3000GS Operating Instructions Manual

Item
[Unicast port1 (Image)]
[Multicast address]
[Multicast port]
[Multicast TTL/HOP Limit]

[User mng.] screen

The [User mng.] screen performs the authentication registration to limit the user or computer (IP address) that can access this unit from a computer.
The [User mng.] screen consists of the [User auth.] tab and [Host auth.] tab.
[User auth.] tab
Performs the authentication registration to limit the user that can access this unit from a computer.
A maximum of 24 users can be registered.
@ NOTE
t When authentication of a computer with an identical IP address has been failed eight times or more in 30 seconds (authentication error), the camera
cannot be accessed for a while.
Item
[User auth.]
[Authentication]
Chapter 5 Web Screen — [Setup] screen
Sets the unicast port number (to be used when images are transmitted from the camera).
This item must be configured when [Transmission type] is set to [Unicast port (MANUAL)].
[1024]...[50000]
Only even numbers can be configured.
10670 and 49152 cannot be set as a port number.
f Factory setting: [32004] ([H.264(1)]), [32014] ([H.264(2)]), [32024] ([H.264(3)]), [32034] ([H.264(4)])
Sets the IP address of the multicast.
The images are transmitted to the specified IP address.
This item must be configured when [Transmission type] is set to [Multicast port].
Before setting, check if it can be used as a multicast IP address.
[224.0.0.0]...[239.255.255.255]
f Factory setting: [239.192.0.20] ([H.264(1)]), [239.192.0.21] ([H.264(2)]), [239.192.0.22] ([H.264(3)]),
[239.192.0.23] ([H.264(4)])
Enter the multicast port number (to be used when images are transmitted from the camera).
This item must be configured when [Transmission type] is set to [Multicast port].
Only even numbers can be configured.
10670 and 49152 cannot be set as a port number.
[1024]...[50000]
f Factory setting: [37004]
Enter the TTL/HOP Limit value of the multicast.
This item must be configured when [Transmission type] is set to [Multicast port].
[1]...[254]
f Factory setting: [16]
When H.264 images are transmitted via Internet, the transmitted images may not be displayed depending
on the settings for the proxy server, firewall, etc. In this case, consult your network administrator.
When multicast images are to be displayed using a computer where multiple LAN cards are installed,
disable the LAN cards that are not to be used for reception.
Sets whether to authenticate users.
[On]: Authenticates the users.
[Off]: Does not authenticate the users.
f Factory setting: [Off]
Sets the authentication method to be used for user authentication.
[Digest or Basic]: Uses Digest authentication or Basic authentication.
[Digest]: Uses Digest authentication.
[Basic]: Uses Basic authentication.
After changing the [Authentication] settings, exit your web browser and access again.
The authentication set here is the authentication method to access the Web screen. It is always a digest
authentication for the connection with the controller.
f Factory setting: [Digest or Basic]
– 86 –
Description of settings
Description of settings