Engaging The Anti-Tip Device - LG LUTD4919SN Installation Manual

24 INSTALLATION
4-Wire Connection: Conduit
WArnInG
• The white middle (neutral) wire of the power
cord or 4-wire conduit has to be connected
to the middle post of the main terminal
block. The other two wires of the power
cord or conduit have to be connected to
the outside posts of the main terminal
connection block. The 4th ground wire
(green) must be connected to the frame of
the range with the ground screw. Failure
to do so can result in electrical shock, severe
personal injury or death.
1
Follow the instructions for installing the conduit
under 3-Wire Connection: Conduit until the strain
relief and bracket are installed. Do not install the
conduit without a strain relief.
2
Loosen the 2 lower left and right screws from
the terminal block. Remove the lower 2 center
screws. Do not discard any screws.
3
Remove the ground screw and bend the end of
the ground strap up so the slot is over the hole
of the center screw removed in step 1.
4
Attach the ground (green) bare wire end to
the range frame and secure it in place with the
ground screw.
5
Insert the bare wire (white/neutral) end through the
center terminal block opening. The center screw
now attaches the bent up ground strap to the block.
6
Insert the two side bare wire ends into the left
and the right terminal block openings. Tighten
the 3 screws securely into the terminal block.
(approximately 35 - 50 IN-LB)
4-wire connection
Black White Red
Wire
ends
Conduit
connection
plate
Ground
Ground
wire
screw
If screws are not tightened securely, it can result in
electrical spark and severe personal injury or death.

Engaging the Anti-tip Device

• Move the range close enough to the opening to
plug into the receptacle.
• Slide the range into position ensuring that the back
leg slides under the anti-tip bracket. The range
should sit flush against the back wall when properly
installed.
• Carefully attempt to tip the range forward to ensure
that the anti-tip bracket is engaged properly. If
properly installed, the anti-tip bracket will prevent
the range from being tipped. If the range can be
tipped, reinstall the range until the anti-tip bracket is
properly installed and the range will not tip forward.
• Turn on electrical power. Check the range for
proper operation.
Test run
Check if the range is properly installed and run a test
cycle.
Terminal
1
block
Ground
strap
2
Bend strap
up and
attach 3
4
5
nOTE
Smoke may come out of the range when it is first
used.
Remove all packing materials from inside the
oven. Press Lower Clear/Off to start the test.
Check the oven's operation. Turn oven mode
knob to select Lower Bake. 350 °F appears in the
display.
Press Start.
The oven should finish preheating in 15 minutes,
and the convection fan should operate while the
oven is preheating.
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on
for at least an hour to help remove any oil which
might cause smoke and odors when first using
the oven.