Connection And Installation - TP-Link CPE220 Installation Manual

2. Connection and Installation

Please connect and install the device as shown in the figure below. The
following introduction takes CPE520 as an example.
LAN0
Ethernet cable length up to 60m
Slide to replace the cover
of the CPE when all
connections are finished.
You should prepare an adequate
Ethernet cable to connect the CPE
and the passive PoE adapter.
Shielded CAT5e (or above) cable
with ground wire is recommended
(refer to the next section).
At the selected site,
approximately align the CPE
to the direction that you
have oriented.
PoE
LAN
Connect to a computer,
router or switch.
(Depending on your
intended usage and/or
network topology.)
06