Setup; Code Saver - GE 29519 Instruction Manual

Setup

Your universal remote requires two (2) AAA
batteries (not included). Alkaline batteries are
recommend.
To Install the Batteries:
1. Remove the battery compartment cover by sliding
the cover down.
2. Match the (+) and (-) marks on the batteries to the
(+) and (-) marks inside the battery compartment,
then insert two (2) AAA Alkaline batteries. Be sure
to use fresh batteries.
3. Slide the battery compartment cover back
into place.
Note: If your remote stops operating properly, replace
the batteries with new ones. The remote will retain
the codes you have programmed for up to 10 minutes
after the batteries are removed.
Battery Precautions:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with local and national regulations.
• Remove batteries if product is to be unused for an
extended period of time.
Battery Saver
Your remote automatically turns off if the buttons are
depressed more than 8 seconds. This will save your
batteries should your remote get stuck in a place
where the buttons remain depressed (e.g., between
the sofa cushions).

Code Saver

You will have up to 10 minutes to change the
batteries in your remote without losing codes you
have programmed. However, do not press any
buttons until batteries are installed in the remote. If
buttons are pressed without batteries in the remote,
all codes will be lost.
3