How To Install Car Seat For Group Ii (15-25Kg) - Snapkis Steps 1-11 User Manual

11. How to install car seat for Group II (15-25kg,
approx. 3 to 7 years)
Removing the 5-point harness system
Step 1: Turn to the bottom of the
car seat
Step 3: From the back of the car
seat, remove both shoulder belts
11
Step 2: Take the buckle metal plate
out from the crotch belt hole.
Step 4: Pull out the 5-point harness
system from the front of the car
seat.
Installing the car seat
Step 1: Place the car seat in the forward facing
position on the vehicle seat. Make sure it is
resting firmly against the vehicle seat
backrest.
Step 2: Place your child on the car
seat.
Step 4: Pass the vehicle lap belt through the lap belt guide slot
under the armrest.
Step 5: Pass the vehicle seat belt over
your child and it should go through the
lap belt route slot under the armrest on
the other side of the car seat.
Important: Do not use any load bearing contact points other than those
!
described in the instructions and marked on the child restraint.
Step 3: Pass the vehicle shoulder
belt through the seat belt route
under headrest.
click
Step 6: Fasten the seat belt into the
buckle properly until you hear a "click"
sound. Tighten the seat belt and
remove any slack.
12