Glensound ADDA 1 User Manual page 11

SWAPPING RACK EARS TO ALLOW THE REAR TO BE INSTALLED AT THE FRONT OF A
PART No
g
Signature
Series
PWR ON
Keeps Working
First remove the 4 silver button head screws that fix the rack ears onto the front of the unit as
shown in the top picture above.
Remove the rack ears and turn the unit around for access to its back panel.
Re-fit the 2 rack ears using the same 4 silver button head screws that were removed from the
front as per the bottom picture above.
USING THE MOUNTING HOLES FOR PERMANENTLY ATTACHING THE UNIT ABOVE OR
PART No
g
Signature
Series
PWR ON
Keeps W orking
Use either the top or bottom mounting holes as indicated above to use suitable screws to
attach the signature unit to a worktop or bench. **PLEASE ENSURE THAT YOU USE SUITABLE
FIXINGS**
RACK
BELOW A WORKTOP/ DESK
PIN 1 = GND
PIN 2 = +12V (100mA) W
PIN 3 = -12V (100mA)
CE
100-240V
+/-12V - - -
50/60Hz 2.7 Watts
Page 11 of 27