Hitachi CP-X205W(C14-20N) Service Manual page 18

CP-X205W (C14-20N) / CP-X305W (C14-25N)
Can't communicate with computer
via NETWORK terminal.
Check at operating mode
Does the Lamp
on lower right of the
Network connector light
in green?
YES
Are
both IP Address
and Subnet mask in the
Network > Information menu set to
"0.0.0.0" after waiting more than
1 minute?
YES
Is
the DHCP in the
Advanced Menu > Network
> DHCP is on?
NO
Set IP address and Subnet Mask
in the Advanced Menu > Network
> IP ADORESS and > SUBNETMASK
menu with manual operation.
Is the computer
NO
connected with the
projector directly?
YES
Is IP Address in
the Network > Information menu
set to "0.0.0.0" after waiting
more than 1 minute?
YES
Are there
any damage to the cable
between computer and
projector?
YES
Use new LAN cable
Subnet Mask is
NO
"255.255.255.0", are
"xxx.yyy.zzz" portion of IP address
setting of computer and
projector
PWB assembly MAIN
Is there
DHCP server on
YES
the network which the
projector is connected
to?
Set IP address and Subnet
Mask in the
NETWORK menu with manual
operation.
18
NO
Make sure NETWORK
NO
PWB assembly NETWORK
NO
PWB assembly NETWORK
PWB assembly MAIN
If
Use the same IP address
NO
setting except for "N" on
computer and projector.
same?
IP address: xxx.yyy.zzz.N
YES
PWB assembly NETWORK
Make sure those settings
YES
of the projector and
computer are correct.
NO
hardware