Table of Contents
Advertisement
Periodic maintenance and adjustment
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Close the shroud.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Open the shroud.
4.
Remove the right side cover and the bot-
tom panel.
1
2
1. Right side cover
2. Screw
3. Bolt
1. Bolt
2. Bottom panel
5.
Place an oil pan under the oil tank to col-
lect the used oil.
6.
Disconnect the oil level gauge coupler.
48
3
2
1
1. Oil level gauge coupler
2. Oil filler cap
7.
Remove the oil filler cap and cylinder
head cap, and then remove the engine oil
drain bolt and its gasket to drain the oil
from the oil tank.
1. Cylinder head cap
2
1. Engine oil drain bolt (oil tank)
2. Gasket
8.
Place an oil pan under the engine to col-
lect the used oil.
Advertisement
Table of Contents
