Hisense HR6FDFF701SW User's Operation Manual page 6

6
the bottom feet may need to be adjusted.
You can adjust them manually by hand or
by using a suitable spanner.
To allow the doors to self-close, tilt the
top backwards by 10-15 mm.
Doors removal
In case when your access door is too
narrow for the refrigerator to pass through,
remove the refrigerator door and drawers.
Then pass the refrigerator laterally. If you
do not need to remove the appliance
doors, go to 'Installing the water lines' on
page 8.If you need to remove the doors,
continue below.
Warning! Disconnect power and shut off
water supply to the fridge before removing
the door or drawer. Failure to do so could
result in death or serious injury.
The tools you will need (Not provided):
Allen Wrench(5mm)
Philips screwdriver
With the fridge doors opened
1. With the door closed, remove the 3
screws holding the top cover (A) with
Philips (+) screwdriver, and then remove
the top cover with the entire-harnesses
attached.
2. Separate the two connectors on the left
side door. To remove the wire connector,
press the top of the connector (B) and
separate it from the other one .To remove
the water coupler from the hinge, twist and
pull the clips from the coupler. Remove the
water line (C) while pressing the movable
part (D) of the water line coupler.
3. Remove the 3 screws (E) fixed on the
Wrench(8mm)