Resetting From The Login Screen - Kanguru Defender 2000 User Manual

2.4.1 Resetting from the Login Screen

In the event you have forgotten your password, you can use the Reset to Factory Default function to reset
your password. This function will restore the device to the factory settings, erasing all saved passwords
and data residing on the device's secure partition.
Caution! Using the Reset to Factory Default function will format and wipe all data off the device! All
data on the device will be lost!
To reset your Defender 2000 to the factory default:
1. Start KDM2000.
2. When the login screen appears, click on the Reset button. Note: The Reset button is not visible if
your device is managed by KRMC or KLA. Please check with your administratror.
3. When you are prompted to confirm the reset, click on the Yes button.
4. When your password and data stored on the secure partition have been erased, the following
message will appear. Click on the OK button to complete the reset.
The next time you run KDM2000, you will have to complete the Setup Wizard again before you are able
to access the secure partition. Please see
completing the Setup Wizard.
section 2.3 The Setup Wizard on page 14
21
Resetting from the Login Screen
for instructions on