Air Purifier Specifications; Controls/Settings; Remote Control - Therapure TPP640S Owner's Manual

8
OPERATING THE THERAPURE

CONTROLS/SETTINGS:

Power Control – To operate the Therapure ® 640S, press the Power
air purifier.
Timer Control – The Therapure 640S air purifier can be programmed to turn off after a preset
®
amount of time. Press the "TIME" button to program the timer. Each press will add one hour up to
a total of 24 hours. Keeping the button pressed will automatically increase to 24 hours, 1 hour at a
time, after that it will turn back to off.
ION Generator – Press the ION button to turn on the IONs. Press it again to turn the IONs off.
Fan Speed Control – The Therapure
® 640S has three different speeds of cleaning, LOW, MED and
HI. Press "SPEED" button to cycle the settings and select the fan speed you desire. The speed state
will be shown on the LED display.
Auto Mode – The Therapure
® 640S is equipped
with an air sensor to monitor the quality of your
air. Simply press the Auto button to activate the
air monitoring system. The monitor will test the
air quality and automatically adjust the fan speed
to remove the air contaminants. The front of the
display is equipped with LED lights to notify you of
the air quality. RED color is for poor, ORANGE for
fair and BLUE for good quality air.
Clean Filter Indicator Light – The Therapure
®
time the filter needs to be cleaned. To reset the filter indicator, press the ION and UV/VOC buttons
together for 3 seconds. The CLEAN FILTER light will flash 3 times and then turn off completely,
indicating the unit has been reset.
Dim Mode – If the LED lights are too bright, activate the "Dim Mode" to turn off the LED lights
and the lighted display. To turn on Dim mode, simultaneously press Auto and Time buttons.
Power indicator, however, will remain lit.
UV Control – Press the UV/VOC control button "UV/VOC" to turn on the UV lamp and the
photocatalyst filter.
TPP
® 640S
button to turn on the
640S Clean Filter Indicator Light will turn on each
OPERATING THE THERAPURE
WARNING:
The remote control has a coin cell battery. Keep the remote and the battery away from
Children. If the battery is ingested, immediately seek medical attention. Never put the coin
battery in your mouth for any reason as they are easily swallowed accidentally. Discard coin
batteries carefully.

REMOTE CONTROL:

Remove the remote from the plastic bag.
Remove the plastic tab from the bottom of the remote by
gently pulling on the tab.
Turn the air purifier on and off by pressing the POWER button.
Control speed with the SPEED button.
Control the timer with the TIME button.
Turn the UV light on and off with the UV/VOC button .
Turn the Auto function on and off with the AUTO button.
Set the air purifier to Dim mode by pressing the DIM button.
To Replace the Battery:
Replace the battery clip by pressing on the release tab
while simultaneously pulling the battery clip out.
Only replace with: CR2025 Lithium cell battery.
Insert the cell in the battery clip with "+" facing up
and insert the battery clip into the remote.
Note: When inserting the battery clip into the remote,
turn the remote backside up.
9
TPP
® 640S
TPP640S