SIIG UltraATA 133 PCI Quick Installation Manual page 6

Windows NT 4.0 Driver Installation
For New Windows NT 4.0 Installation
1. Install the board and follow Microsoft procedures to install
Windows NT 4.0 accordingly.
2. At the Windows Setup screen, press F6 to specify and add the
driver.
3. Press S, select Other, then press Enter.
4. Insert the driver diskette and press Enter.
5. Select SiI 0680 ATA/133 Controller for NT 4.0 and press
Enter.
6. Press Enter to continue and follow on-screen instructions to
complete Windows NT 4.0 installation.
For Existing Windows NT 4.0 Installation
1. Install the board and boot up Windows NT 4.0.
2. Double click My Computer/Control Panel/SCSI Adapters,
then click the Drivers tab.
3. Click Add... then Have Disk....
4. Insert the driver diskette, type in A:, then click OK.
5. Highlight SiI 0680 ATA/133 Controller and click OK.
6. Click OK, remove the driver diskette and restart NT to
complete driver installation.
Verify Proper Installation for Windows NT 4.0
1. Double click My Computer/Control Panel/SCSI Adapters.
2. Highlight SiI 0680 ATA/133 Controller from SCSI Adapters
listing and click Properties. A message This device is working
properly is displayed in the dialog box, the driver has been
correctly installed.
6