SIIG UltraATA 133 PCI Quick Installation Manual page 5

Windows ME Driver Installation
For New Windows ME Installation
1. Install the board and follow Microsoft procedures to install
Windows ME accordingly.
2. Once Windows has been installed, right click My Computer,
then click Properties. Select Device Manager tab.
3. Double click PCI Mass Storage Controller listed under Other
Devices.
4. Select Driver tab, then click Update Driver button.
5. Insert the driver diskette, select Automatic search for a better
driver (Recommended), then click Next.
6. Click Finish, remove the driver diskette and click Yes to
restart Windows to complete driver installation.
For Existing Windows ME Installation
1. Install the board and boot up Windows ME.
2. At the Add New Hardware Wizard, insert the driver diskette.
3. Select Automatic search for a better driver (Recommended),
then click Next.
4. Click Finish.
5. Remove the driver diskette and restart Windows to complete
driver installation.
Verify Proper Installation for Windows 98 SE/ME
1. Right-click My Computer, then click Properties. Select
Device Manager tab.
2. Double click Hard Disk Controllers, an entry, SiI 0680 ATA/
133 Controller should be listed.
3. Highlight SiI 0680 ATA/133 Controller and click Properties.
A message This device is working properly is displayed in the
dialog box, the driver has been correctly installed. If any error
message is displayed, remove SiI 0680 ATA/133 Controller
and restart your system.
5