Installation Process - Audiovox car connection 2.0 User Manual

Installation Process

Please follow these steps and the SYNC guide (next
page) in order to connect to Network & GPS – this
process may take up to 15 Minutes:
1. Make sure vehicle is in open view of the sky.
2. Plug device into OBDII port.
3. Start the vehicle– you should see the LEDs light up on the front of the device.
4. If for any reason you do NOT see the LEDs light up, with the device installed and engine
running, unplug the device and repeat steps 2 and 3.
Once you see the LEDs flashing – please leave the device plugged in for at least 5 minutes.
5.
6. If your device has a SOLID Cellular light after 5 minutes - the SYNC process is complete.
If not, please POWER CYCLE (Instructions below) to restart SYNC process.
Once the SYNC process is complete – log into your Car Connection 2.0 MOIBLE APP
7.
or WEBSITE to review location, vehicle and account information.
NOTE: Data may not appear on your account until you go for a drive.
1. Un-plug device from OBDII port – for ~15 seconds
2. Start your vehicle's engine
3. Plug device into OBDII port – with ENGINE RUNNING
4. Wait approximately 5-10 minutes – with ENGINE RUNNING
NOTE: Reference SYNC Guide for more information.
5. Turn off vehicle/engine
For more information, including FAQs, please visit www.CarConnection20.com
HOW TO POWER CYCLE
For technical assistance, please call 1-800-300-4550