Advertisement
9. Optional – If you are not planning on using the equipment cut-outs, you may
want to glue or tape them in place before flying.
10. Setting up the RMRC Mako for maiden flight:
a. After you have successfully installed and bound your radio and receiver,
verify that all channels are operating on the correct controller input and
in the correct direction for flight. The Mako will require "mixing" since it
is a model with elevons.
b. Set the elevon throws to 100% or approximately 15mm of travel in both
directions. (Measured in relation of the elevon to the wing)
c. Center of Gravity (CG) is achieved directly on the raised lettering on the
bottom of the wings (24mm forward of the wing spar). We recommend
that the model is slightly nose heavy for the maiden flight.
d. Without FPV gear installed, we fly with an RMRC 3300 3s battery.
e. While the Mako is an easy plane to hand launch, we recommend having a
qualified person to launch for the maiden flight.
f. If you have any further questions, please contact us at:
http://readymaderc.com/support/
Page | 10
Advertisement
