Domestic DC Blue Advanced Pico User Instructionsructions page 14

A QUICK METHOD OF LEARNING A TRANSMITTER BUTTON CODE INTO THE RECEIVER MEMORY WITHOUT ENTERING THE
NB!! No remote codes can be learnt into the (LT) courtesy light channel this way.
Door must be closed
Press and hold the "Up"
button until buzzer beeps and
display shows "b".
Press and hold required
remote button.
Press and release the "SET"
button.
Release both the remote
button and "SET" button
ET DC BLUE ADVANCED USER 2013.012.24.11.2016
PROGRAMMING MENU.
Max users (BT) button trigger channel = 35 user codes
Action
Door closed
Buzzer beeps once and display
shows "b"
LED on remote transmitter
remains lit.
"1" on display and 1 beep =
user code successfully
registered.
"2" on display and 2 beeps =
user code already in the
receiver memory.
"3" on display and 3 beeps =
Unsuccessful because no code
was seen within 4 sec of the
"SET" button being pressed.
Mandatory timeout.
"F" on display and multiple
rapid beeps = Memory full
Display reverts back standby
mode "II"
14
www.et.co.za
Response
Successful
Code already in
memory
Unsuccessful
Memory full