Table of Contents
Advertisement
If you select PPPoE network configuration, after finish the
information input and click "Finish" button, it will notice you
connect net-TV Box to ADSL Modem and replug in the
power source.
Please plug out the Ethernet Cable from the computer
which is connected to net-TV Box and reconnect it to the
xDSL Modem that has been set.
Plug on the power of net-TV Box after the Ethernet Cable is
properly connected. Please notice the order of the two
steps: Connect Ethernet Cable first, then plug on the
power. Then the PWR led of the net-TV Box will turn
constant on, you should notice whether the NET led is on
afterwards. If so, congratulate that you have installed
successfully, if not, please retry by above steps.
Port Forwarding:
The default setting is UPnP Auto. If the effect of automatic port isn't satisfying, you can set the ports for yourself.
If the router supports UPnP, please don't select DMZ or Virtual Server. If you select the item (only available under
LAN) you have to enter the corresponding ports in the following fields. (Please refer to instructions of router.)
87
<<
>>
Advertisement
Table of Contents
