Philips HTS3578W User Manual page 41

[Speakers Volume]
Sets the volume level of each speaker to get
the ideal audio balance.
1) To start, press OK .
2) Select a speaker in the menu, then press
to adjust the volume level.
3) Press OK to confi rm and exit.
Note
•
The test tone is emitted from the speaker which you
adjust.
[Speakers Delay]
Sets the delay time for the centre and rear
speakers if they are placed closer to the
listening position, so that the sound output from
all speakers reaches the listening position at the
same time.
1) To start, press OK .
2) Select a speaker in the menu, then press
to set the delay time.
3) Press OK to confi rm and exit.
Note
•
Allow 1ms setting for every 1 foot distance between
the speaker and the listening position.
[HDMI Audio]
Selects the HDMI audio setting when you
connect this Home Theater System and the TV
with a HDMI cable.
• [On] – Allows audio output through the
TV and the speaker system. If the audio
format on the disc is not supported, it
will be downmixed to two-channel sound
(linear-PCM).
[Off] – Disables audio output from the
•
TV. The sound is only output through the
speaker system.
[CD Upsampling]
Converts the music CD to a higher sampling
rate using sophisticated digital signal processing
for better sound quality.
[Off] – Disables CD-upsampling.
•
[88.2kHz (X2)] – Converts the sampling
•
rate of the CDs twice as high as the
original rate.
Note
•
CD upsampling is only available in stereo mode.
[Audio Sync]
Sets the default delay time for audio output
when you play a video disc.
1) To start, press OK .
2) Select a speaker delay in the menu, then
press to set the delay time.
3) Press OK to confi rm and exit.
EN
41