Using Wi-Fi Direct - Zte CRICKETBlade X Max User Manual

Connecting to a WPS network
Wi-Fi Protected Setup (WPS) is a feature that makes it easy to add your phone
to access points that support WPS .
You can use one of the following methods to connect your phone to a
wireless network using WPS .
Method one: WPS button (Recommended)
1 . Press the Home key > > Settings > Wi-Fi .
2 . Slide the Wi-Fi switch to the On
> Advanced > WPS Push Button .
3 . Tap
4 . Press the WPS button on the access point, and it will recognize your phone
and add it to the network .
Method two: PIN
1 . Press the Home key > > Settings > Wi-Fi .
2 . Slide the Wi-Fi switch to the On
> Advanced > WPS Pin Entry .
3 . Tap
4 . The WPS PIN displays on the screen . Enter the PIN into the access point's
setup page .
After entering the PIN, your phone automatically finds the access point and
configures the connection .
Note: For detailed information about the WPS feature of the access point,
please refer to its documentation .
Adjusting advanced Wi-Fi settings
1 . Press the Home key > > Settings > Wi-Fi .
42
position .
position .
CONNECTING TO NETWORKS AND DEVICES
2 . Tap to adjust the following settings .
• Network notification: Get notifications in the Status Bar when Wi-Fi is on
and an open network is available .
• Keep Wi-Fi on during sleep: Set whether to keep Wi-Fi on in Sleep mode .
• MAC address: Check the MAC address .
• IP address: Check the phone's IP address .
3 . From the main Wi-Fi menu, tap > Advanced to adjust the following settings .
• Install certificates: Install certificates needed for connecting to certain
Wi-Fi networks .
• Wi-Fi Direct: Use the Wi-Fi Direct feature . (See Using Wi-Fi Direct below .)
• WPS Push Button: Connect to a WPS network via the push button method .
• WPS Pin Entry: Connect to a WPS network via the phone PIN method .

Using Wi-Fi Direct

Wi-Fi Direct allows Wi-Fi devices to connect to each other without the need for
wireless access points (hotspots) . Your phone supports Wi-Fi Direct, but you
may need to install third-party applications to share data through Wi-Fi Direct .
Note: Activating this feature will disconnect your current Wi-Fi network
connection .
To connect to another device:
1 . Press the Home key > > Settings > Wi-Fi .
2 . If Wi-Fi is off, slide the Wi-Fi switch to the On
3 . Tap > Advanced > Wi-Fi Direct . Your phone will search for other devices
enabled with Wi-Fi Direct connections .
CONNECTING TO NETWORKS AND DEVICES
position .
43