Turn�Ng The D�Splay On/Off - Toshiba TD-E433 Owner's Manual

Connecting the IR Receiver
Before plugging the Display into the mains supply, connect
the supplied IR receiver to the IR input on the Display. Place
the IR receiver in sight of your own remote control. Simply
operate your remote control whilst pointed at the IR receiver
and it will relay the control signal to your Display.
Turning the Display On/Off
Press the Standby button on the remote or press the centre of the joystick in located on rear left side of the
Display to switch it on from standby . Press the centre of the joystick in and hold it down for a few seconds or
press the Standby button on the remote to switch display into standby mode.
LED Status
Power led not lit
Power led lit
Power led flashing (Slow)
Power LED flashing (Fast)
Joyst�ck
V+
V-
Status of the monitor
Power on
Power off (Standby mode)
Scheduler active
Power up / down and Sw update
English - 9 -