Audio setup
1
Press OPTIONS.
[ General Setup ] menu is displayed.
2
Press V to select
press B.
3
Select an option, then press OK.
Audio Setup
HDMI Audio
Audio Sync
Night Mode
CD Upsampling
•
See the explanations of the above
options in the following pages.
4
Select a setting, then press OK.
•
To return to the previous menu, press
BACK.
•
To exit the menu, press
[ HDMI Audio ]
When you connect this unit and TV with
HDMI cable, select the audio output
setting for this connection.
•
[ On ]
– the sound is output through
both your TV and this speaker system.
If the audio format on the disc is not
supported, it will be downmixed to
two-channel sound (linear-PCM).
[
Off ] – disable audio output from
•
your TV. The sound is only output
through this speaker system.
30 EN
[ Audio Setup ], then
OPTIONS.
[ Audio Sync ]
Set the default delay time for audio output
when you play a video disc.
1.
To start, press
OK.
2.
Press
b B to set the delay time.
3.
OK to confi rm and exit.
Press
[ Night Mode ]
Make loud sound level softer and soft
sound level louder so that you can watch
the DVD movies at a low volume, without
disturbing others.
Note
•
This setting is only applicable to Dolby Digital
encoded DVD.
•
[
On ] – for quiet viewing at night
(DVDs only).
•
[
Off ] – enjoy surround sound with a
full dynamic range.
[ CD Upsampling ]
Convert the music CD to a higher
sampling rate using sophisticated digital
signal processing for better sound quality.
[
Off ] – turn off CD-upsampling.
•
[
On ] – convert the sampling rate of
•
the CDs twice as high as the original
rate.