Using S-Video Jack; Using An Accessory Rf Modulator - Philips 78 User Manual

Option 3
OOFER
2 1
IMPORTANT!
If S-Video is used for DVD playback,
the system's VIDEO OUT setting will
need to be changed accordingly.
Details are on page 23.

Using S-Video jack

1
Use an S-video cable (not supplied) to
connect the DVD system's S-VIDEO
OUT jack to the S-Video input jack
(or labelled as Y/C or S-VHS) on the TV.
2
To hear the TV channels through this
DVD system, use the supplied audio
cables (white/ red) to connect AUDIO
IN-TV) jacks to the corresponding
AUDIO OUT jacks on the TV.
3
Set the P-SCAN switch to 'OFF'.
001-035-MX2500D-78-Eng2
3
9
Connections
Option 4
ANT IN
RF coaxial cable to TV
2
INT IN
3
Antenna or
Cable TV signal
1
REAR SUBWOOFER
LEFT
4
IMPORTANT!
If your TV only has a single Antenna In
jack (labelled as 75 ohm or RF In),
you will need an RF modulator in
order to view DVD playback on the
TV. See your electronics retailer or
contact Philips for details on RF
modulator availability and operations.

Using an accessory RF modulator

1
Use the supplied composite video cable
(yellow) to connect the DVD system's
VIDEO OUT jack to the video input
jack on the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV).
4
Set the P-SCAN switch to 'OFF'.
7/20/04, 3:11 PM
Back of RF Modulator
(example only)
TO TV AUDIO IN
VIDEO
IN
R L
CH3 CH4
9
8239 300 32892