Led Indicators - XIIMUS 1024CTI User Manual

Supply voltage:
Nominal:
Range:
Supply current:
Typically:
Maximum:
Ripple:
± 10 % (max 120 Hz)
5.2

LED indicators

From top downwards the LEDs are as follows:
POWER, green
ON:
RUN, green
ON:
OFF:
STATUS 1, green
ON:
OFF:
STATUS 2, green
ON:
OFF:
PWR ERROR, red
ON:
© TVI Vision, 18 October 2006
XIIMUS R-GB-IR CL User Manual.
+24 V
DC
+20 to +36 V
DC
500 to 1000 mA
1.1 A (at +24 V
DC
- voltage level (=nominal + ripple) must stay
between +20 to +36 V
power input OK
normal operation
¹ The higher temperature limit has been exceeded and the
camera operation has been shut down. After the external tem-
perature has fallen into the specified range, switch the power
once OFF and then ON again.
² The camera did not start up properly. Check the input power
lines and the POWER LED. The power supply must be able to
supply enough current quickly at beginning of the power-up.
correction unit (PCU) is enabled
correction unit (PCU) is disabled
camera is ready for operation
camera is performing internal boot cycle
at least one of the internal supply voltages has failed
and at power-up only)
Version 1.2
page 17 ( 57 )