Scan monitors for signals on the transceiver channels. While scanning, the
transceiver checks for a signal on each channel and only stops if a matching
signal is present.
To start/ stop scanning, press the key programmed as [Scan].
•
"Sc" appears on the display during Scan.
•
When a signal is detected, Scan pauses at that channel. The transceiver will
remain on the busy channel until the signal is no longer present, at which time
Scan resumes.
Note:
◆ To use Scan, there must be at least 2 channels added to the scanning sequence.
PRIORITY SCAN
If a Priority channel has been programmed, the transceiver will automatically
change to the Priority channel when a call is received on that channel, even if call
is being received on a normal channel.
•
"P1" appears on the display to indicate the Priority channel 1.
•
"P2" appears on the display to indicate the Priority channel 2.
•
"PP" appears on the display to indicate the Priority channels 1 and 2.
TEMPORARY CHANNEL LOCKOUT
During scan, you can temporarily remove specific channels from the scanning
sequence by pressing the key programmed as [Scan Delete/Add] while Scan is
paused at the undesired channel.
•
The channel is no longer scanned. However, when scanning is ended and
restarted, the Scan settings return to normal.
SCAN DELETE/ ADD
You can add and remove zones and/or channels to and from your scan list.
1 Select your desired zone and/or channel.
2 Press the key programmed as [Zone Delete/Add] (to add/remove zones) or
[Scan Delete/Add] (to add/remove channels).
•
When a zone is added to scan, "GA" appears on the display. When it is
removed, "Gd" appears on the display.
•
When a channel is added to scan, "cA" appears on the display. When it is
removed, "cd" appears on the display.
SCAN
18