Programme End; Switching Off The Appliance; Interrupting The Programme; Terminating The Programme - NEFF S series Instruction Manual

Programme end

The programme has finished when the
value ‹‹h:‹‹m appears in the display
window )". If a value has been set for
the signal volume, then the end of the
programme is also indicated audibly by
a buzzer.
* The end of the programme is
displayed on the floor – provided the
TimeLight (optical display) is switched
on and is visible.
Note: When Eco drying is activated, the
end of the programme is not indicated
by a buzzer.
* depending on the features of your
dishwasher

Switching off the appliance

Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
About the Eco drying function:
When Eco drying is activated in the
Eco 50° programme, the door opens
automatically when the programme
ends. This ensures the best possible
drying result. Low amounts of steam
may occur. If you install the appliance
under a worktop, fit the supplied
steam protection film * (follow the
procedures in the installation
instructions). The steam protection film
protects sensitive fitted furniture and
worktops from damage by water
vapour. Before opening the appliance,
leave it to cool down for a while in the
remaining programmes when the
programme ends.
Operating the appliance en

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.

Terminating the programme

(Reset)
Open the door.
1.
p r o g r a m m e T e r m i n a t i n g t h e
Press the START button h and
2.
hold it down for about 3 seconds.
The value ‹‹h:‹‚m appears in the
display window )".
Close the door. The programme
3.
sequence lasts about 1 minute.
The value ‹‹h:‹‹m appears in the
display window )".
Open the door.
4.
Switch off ON/OFF switch (.
5.
Close the door.
6.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
33