Advertisement
H-racer
What do you need?
Position the fuel cell onto the square slot located in the middle of the
car chassis behind the black motor. Firmly push the front of the fuel cell
into the chassis until you hear a click.
Connect the red wire of the chassis to the red jack of the fuel cell.
Connect the black wire of the chassis to the black jack of the fuel cell.
Warning: Make sure these connections are correct. Any other
connection will destroy the operation of the car and its fuel cell
power system. Also ensure the wires are not touching the
wheels.
Slide the refueling input valve into its mount, located at the
opening on the side of the chassis. Make sure that the small
ridges on the outer edge of the input valve are positioned at the
sides. With a downward motion, click the valve into place
ensuring it is smoothly aligned with the outer surface of the
chassis.
Position the hydrogen storage cylinder onto the two mounts
located directly above the rectangular opening on the chassis.
Once the cylinder is positioned on the two mounts, press lightly
until it fits onto the structure. To avoid damage or breakage, be
careful not to press the cylinder onto the mounts with too much
force.
Connect the other end of refueling input valve tube to the
nozzle closest to the red jack of the fuel cell. Connect the other
end of the hydrogen storage cylinder's tube onto the fuel cell
nozzle closest to the black jack.
H-Racer
AA batteries=2 Units
ASSEMBLY GUIDE
Connect one of the flexible tubes to the nozzle
located on the input valve.
Connect the second flexible tube to the nozzle
located on the lid of the hydrogen storage cylinder.
Position the upper body of the car and place it
above the chassis. Align the holes on the chassis
with the holes on the car top body.
Use a screwdriver (not included) to attach the body
to the chassis using the set of 4 small screws and
make sure the screws are entered straight into the
chassis. Do not tighten the screws until all screws
are partially entered the screws until all screws are
partially entered until no gaps are left between the
body and the chassis.
Remove the H
sticker from its backing and position
2
it on the car accordingly.
The assembly of your H-racer is now
completed.
Water=25ml
Advertisement
