Water Pressure - Oliver Legacy Elite II2017 Owner's Manual

Water Pressure

Note: When trying to drain entire on-board fresh water system, make sure to
open faucets and remove water heater drain plug. This will equalize the air
pressure and allow free water flow.
Water Pump
When using water from the fresh water tank, the system must be pressurized.
A self- priming 12-volt DC pump, is provided to handle this function. A
pump on/off switch is located in the attic (Elite II) and under the sink (Elite).
When initially starting up the self contained water system:
1. Make sure the tank is filled with water.
2. Open all faucets in the Oliver both hot and cold.
3. Place the pump control switch in the ON position.
4. Allow time for the hot water tank to fill. Shut off each faucet as the flow
becomes steady and free of air. When the last faucet is shut off, the pump
should also shut off.
5. The system is now ready for use.
The self-contained water system is a demand system. This means that the
water pump will run whenever there is a need for water.
FRESH WATER DEMAND SYSTEM
Sanitizing the Fresh Water System
Sanitize the system before initial use; after extended periods of non-use; at
least once a year during continuous use; and whenever there is suspicion that
the system has been contaminated.
1. Prepare a chlorine solution using a gallon of water and 1⁄4 cup of
liquid household bleach (5% sodium hypo chlorinate solution). Use
one gallon of solution for each 15 gallons of tank capacity.
2. Using the transfer hose supplied at the water pump and, turning the
diverter valves to the correct position, pumps the solution into the
fresh water tank.
69